Surface Enhancement (SE) is a metal treatment process that uses repetitive high impacts to induce a compressive stress layer in the surface of Aerospace parts. This compressive layer can overcome the tensile stresses caused by machining, by inhibiting cracks from growing. This will increase the lifespan of parts by, in most cases, many millions of cycles in comparison to untreated parts. Another term used for Surface Enhancement is shot peening.
Shot peening is the process of using shot (media) as the objects to impact the part. SE covers processes such as Computer Controlled Peening, Automated Peening, Peen Forming, Flapper Peening, Manual Peening, and Needle Peening. If SE is not performed correctly in accordance with the engineering requirements it can lead to premature part failure which is why oversight of this process is critical in the Aerospace Industry.
The SE Task Group’s first Audits occurred in 2002 to control this process in Aerospace applications. Later in the late 2000’s because the NM and SE Task Groups were of a comparable size the groups were combined into the NMSE Task Group and oversight was provided by the same group of Subscribers. Today, the SE Task Group performs approximately 215 Audits annually and holds 279 supplier accreditations.
View our "How to Get Started" page and walk through the necessary steps you'll need to take and get resources or create an EAN account to request a quote.

What are SE Industry Challenges?
- Improper documentation of the process
- Failure of program and software controls
- Improper process to build a saturation curve
- Failure of verification of intensity
- Improper media shape and size inspection
- No reverification of equipment after measurement of calibration setup

How a Nadcap SE Accreditation Supports You
- Reduced costs associated with product malfunction, returns, complaints and equipment failure
- Improved reputation and credibility in the industry
- The equipment calibration processes and requirements
- Operator qualification and training
- The process of hardware inspection including part set-up and fixturing
SE Nadcap Audit Criteria
AC7117 – SE Accreditation
AC7117/1 – Computer Controlled Peening
AC7117/2 – Automated Peening
AC7117/3 – Peen Forming
AC7117/4 – Flapper Peening
AC7117/5 – Manual Peening
AC7117/6 – Pneumatic Needle PeeningThe PRI EANSM platform provides suppliers with a single place to view, understand, and navigate Nadcap Audit Criteria so you know exactly what will be assessed before, during, and after an audit. Create an EAN account to access the criteria and learn what you need to know to support your Nadcap accreditation.
Common Nonconformances Found During an SE Audit
- Content
AC7117, 6.4.2 Is media shape inspected in accordance with the specified method and recorded at the required intervals of run time?
- Content
AC7117, 2.6.5 Did the Auditee upload an active specification list to eAuditNet prior to the audit?
- Content
AC7117/2, 9.6.17 Is nozzle or wheel position to the part listed on the technique sheet and correctly followed in production?
- Content
AC7117/2, 9.6.14 Are all process monitoring equipment and/or gauges identified as to their calibration status and current?
