Conventional Machining as a Special Process (CMSP) expands traditional machining by tightly controlling process variables to prevent unintended changes to the physical, chemical, or metallurgical properties of a part, changes that cannot always be detected through nondestructive inspection.
By controlling these parameters, CMSP helps prevent issues such as residual tensile stresses, tearing, and crack propagation that can lead to failures in critical components like rotating parts and landing gear. This controlled approach to material removal allows engineering teams to design fuel-effcient aircraft while ensuring components operate safely at their intended loads throughout their projected service life.
The CMSP Task Group was established in 2009 to address machining variables that have contributed to serious industry failures, including component and landing gear failures that resulted in aircraft damage and loss of life. These issues were often undetectable at the time of manufacture using nondestructive methods, underscoring the need for stricter process controls. Today, the CMSP Task Group conducts approximately 80–110 audits annually, with roughly 200 suppliers holding
CMSP accreditation under the Nadcap® program.View our "How to Get Started" page and walk through the necessary steps you'll need to take and get resources or create an EAN account to request a quote.

What are CMSP Industry Challenges?
- The process as it is performed no longer is identical to the Technical Plan as it was approved by the Customer
- Not developed their process with their customer focus prior to entering Nadcap are more likely to have more NCRs on their initial audit

How a Nadcap CMSP Accreditation Supports You
- Reduced risk of component failure
- Increased OEM confidence
- Improved process consistency and operaltional efficiency
CMSP Nadcap Audit Criteria
AC7126 - Conventional Machining as anSpecial Process
AC7126/1 - Holemaking
AC7126/2 - Broaching
AC7126/3 - Turning
AC7126/4 - Milling
AC7126/5 - Grinding
AC7126/6 - Edge TreatmentThe PRI EANSM platform provides suppliers with a single place to view, understand, and navigate Nadcap Audit Criteria so you know exactly what will be assessed before, during, and after an audit. Create an EAN account to access the criteria and learn what you need to know to support your Nadcap accreditation.
Common Nonconformances Found During an CMSP Audit
- Content
For the cutting fluid(s) in use, is there a procedure for maintenance that covers the following elements, including frequency of testing? Based on the type of cutting fluids used, the table below indicates if an element is applicable (A) or not applicable (B).
In most instances, the cutting fluid is not controlling one or more of the variables defined by the CMSP Task Group.
- Content
Does the procedure control which gages do not require calibration and how they are to be identified?
In many cases, suppliers have gages in the work cell that are not part of the CMSP process and have not been identified as reference only. Additionally, suppliers experience diffculty remaining current with their calibration system in general.
- Content
Does the Auditee have a procedure for equipment qualification and/or calibration, including re-qualification intervals, and does it meet customer requirements where applicable?
CAG: Per Customer requirements, items
that require calibration or verification of
accuracy may include :
1. Machine validation (spindle speeds, feedrate, axis movement, alarms, etc.)
2. Coolant pressure (when coolant pressure specified or coolant fedtools used)
3. Coolant temperature (when specified)
4. Coolant concentration device (e.g. refractometer)
5. Pressure gauge for coolant filtering system
6. Fixtures
- Content
Unless the machine is operated at a single value (e.g. one spindle speed), all calibrations shall be performed at least two test points that cover the range of use of
the unit.
In most cases the supplier is not controlling one or more of the required calibration or machine requalification parameters or intervals.
